Suitable for HUSKYLOCK™ S25 and S21 and AMBER™ AIR s|600 Overlockers With the Clear Coverstitch Foot, you can see your fabric and marked line under the foot as you sew. How to use: Set the machine for a Coverstitch or a Chainstitch. With a water-soluble marker, draw a line on the fabric to mark the stitching line. Snap-on the Clear Coverstitch foot. Use default stitch settings. Adjust if needed. Place the fabric under the presser foot and the needles. Start to sew into the fabric without chaining off first. Use the red centre marking on the foot as a guide as you follow a line drawn on the fabric. The Clear Coverstitch foot will give you a great view of the marked line and of your fabric while sewing.

Sewing a decorative wavy edge with the Corded Wavy Edge Foot is easy. The curvy, softly ruffled edge is a perfect finish for bridal veils, figure skating costumes, ballet skirts, crafts and more. Note: For best results, use fabric with stretch. For fabric with no stretch, cut on the bias. How to use: Set the machine for a 3-thread rolled edge. Snap-on the Corded Wavy Edge foot. Insert a 0.3mm nylon fishing line (or similar) into the opening in the foot. The fishing line will be covered by the rolled edge. Start to sew slowly. Make sure the fishing line is hidden in the rolled edge as you sew. Tip: * 40 wt. rayon embroidery threads in a contrasting colour in the upper and lower loopers will give a shiny colourful edge.

Suitable for S25 and S21 Overlockers With the Piping Foot with Cording Guide, you can create piping, corded tucks and decorative trims. Easily create your own piping: Set the machine for Chainstitch. Use the default stitch settings. Adjust if needed. Note: Although the machine recommends needle D, you will use needle E for this technique instead. Snap on the Piping foot. (The cording guide is not used for this technique.) Place the cord in the groove on the bottom of the foot and pull the cord tail behind the foot about 2½” (5cm). Note: ¼” - 5/8” (1.5 - 2.0mm) cord can be used. Cut a strip of fabric on the bias, 1” (25mm) wide. Wrap the fabric around the cord in the front of the foot. Slide the fabric under the foot. Lower the presser foot and sew over the cord and fabric (illustration 1). (Hold the cord behind the foot as you begin to sew.)